23182 2WD/4WD Cam/Cas Sleeve 1/2 Degree

These popular sleeves are widely used to adjust caster and/or camber on many Ford and Mazda 2/4WD trucks. To install, simply loosen and remove upper ball joint pinch bolt. Remove top snap ring if one is present. Use 77880 or 88830 sleeve puller to remove the existing sleeve. To save time during alignment, use 23199 zero degree sleeve to determine initial readings, then install correct sleeve. Note: Sleeves adjust to a smaller degree on Ford 4WD light trucks.

- To save time during alignment, use the 23199 zero sleeve to determine initial readings

- Adjustment Range: Cam./Cas. ±.25 degree to ±3.50 Degree

- Installation Time: .5 hr/side

- Required: 1 Per Wheel

- Recommended Tools: 77880 - Sleeve Puller, 88830 - Sleeve Puller, 87175 - Special Socket

About this part

The 23182 is a Specialty Products 1/2 degree camber and caster sleeve for 2WD and 4WD trucks. These sleeves are widely used on many Ford and Mazda 2/4WD trucks. To install, remove the upper ball joint pinch bolt, then the old sleeve with a sleeve puller. The adjustment range across the sleeve series is plus or minus .25 to 3.50 degrees.

Also called: specialty products company, caster sleeve sets, cambers, casters

Also listed as: 23182, 231-23182, 231-56502, I-23182

Borg item #:

SP23182

Cross-References:

Ascot No. 231-23182

California Prop 65 Warning:

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov