23183 2WD/4WD Cam/Cas Sleeve 3/4 Degree

2WD Adjust .75 Degree Total Change

4WD Adjust .60 Degree Total Change

These popular sleeves are widely used to adjust caster and/or camber on many Ford and Mazda 2/4WD trucks. To install, simply loosen and remove upper ball joint pinch bolt. Remove top snap ring if one is present. Use 77880 or 88830 sleeve puller to remove the existing sleeve. To save time during alignment, use 23199 zero degree sleeve to determine initial readings, then install correct sleeve. Note: Sleeves adjust to a smaller degree on Ford 4WD light trucks.

- To save time during alignment, use the 23199 zero sleeve to determine initial readings

- Adjustment Range: Cam./Cas. ±.25 degree to ±3.50 Degree

- Installation Time: .5 hr/side

- Required: 1 Per Wheel

- Recommended Tools: 77880 - Sleeve Puller, 88830 - Sleeve Puller, 87175 - Special Socket

About this part

The 23183 is a 3/4 degree 2WD/4WD cam/cas sleeve for adjusting caster and camber on many Ford and Mazda 2WD and 4WD trucks. Total change is .75 degree on 2WD and .60 degree on 4WD. Use a 77880 or 88830 sleeve puller to remove the old sleeve, and the 23199 zero degree sleeve to take initial readings. Install time is .5 hr per side, one per wheel.

Also called: specialty products company, caster sleeve sets, cambers, casters

Also listed as: 23183, 231-23183, I-23183

Borg item #:

SP23183

Cross-References:

Ascot No. 231-23183

California Prop 65 Warning:

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov