23188 2WD/4WD Cam/Cas Sleeve 2 Degree

2WD Adjust 2.00 Degree Total Change

4WD Adjust 1.40 Degree Total Change

These popular sleeves are widely used to adjust caster and/or camber on many Ford and Mazda 2/4WD trucks. To install, simply loosen and remove upper ball joint pinch bolt. Remove top snap ring if one is present. Use 77880 or 88830 sleeve puller to remove the existing sleeve. To save time during alignment, use 23199 zero degree sleeve to determine initial readings, then install correct sleeve. Note: Sleeves adjust to a smaller degree on Ford 4WD light trucks.

To save time during alignment, use the 23199 zero sleeve to determine initial readings

Adjustment Range: Cam./Cas. ±.25 degree to ±3.50 Degree

Installation Time: .5 hr/side

Required: 1 Per Wheel

Recommended Tools: 77880 - Sleeve Puller, 88830 - Sleeve Puller, 87175 - Special Socket

About this part

The 23188 is a Specialty Products 2 degree camber and caster sleeve for 2WD and 4WD trucks. It changes alignment by 2.00 degrees total on 2WD and 1.40 degrees on 4WD, and is widely used on many Ford and Mazda 2/4WD trucks. Install it by removing the upper ball joint pinch bolt and the old sleeve with a sleeve puller.

Also called: specialty products company, caster sleeve sets, cambers, casters

Also listed as: 23188, 231-23188, 231-56508, I-23188

Borg item #:

SP23188

Cross-References:

Ascot No. 231-23188

California Prop 65 Warning:

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov